Line 1/Line 2 Setup

The Line Setup tabs give detailed information about the VoIP network and may be switched between Standard and Advanced view. The default view is Standard, and may be changed by clicking the button shown below:

Settings for Line 1 and Line 2 are identical.

In Standard view, a user will have the option of configuring a SIP Config tab, Features and Dial Plan settings. In Advanced view, the user is given additional options under these tabs and the option of configuring Quality of Service, Network Address Translation (NAT) and Voice Features.

Features - Standard View

Settings under the Features tab are as follows:   Tones

• DTMF Transmit Level- controls the transmitted DTMF tone level. Range is -100 to 0.
• Local DTMF Level - controls the local volume of generated DTMF tones. Range is -100 to 0.
• Local DTMF Mute - turns local DTMF generation off/on.

Call Features

• Redial - allows the previously dialed number to be recalled.
• Auto Answer - pick up the call automatically after the ring count duration has passed.
• Auto Answer Ring Count - designates when to auto answer. Range is Immediately or 1-3 rings.
• Caller Id - shows the Caller ID in TTP updates and Dialer.
• Consultative Transfer - the transfer process will connect the second party to a third party after the third party answers and agrees to take the call (support is dependant on phone system).

Saving/Applying Changes   When making changes, the user must make sure to apply changes in order for them to take affect. Clicking save changes will not apply the configuration changes to the VoIP card, but rather save them in a memory cache. If a user saves changes and navigates away from the current tab, the changes are still stored. If changes are saved yet not applied and the device is rebooted, changes will be lost.   A user must click Apply Saved Changes to make the changes active.