Line 1/Line
2 Setup
The Line
Setup tabs give detailed information about the VoIP network and may be
switched between Standard and Advanced view. The default view is Standard,
and may be changed by clicking the button shown below:
Settings
for Line 1 and Line 2 are identical.
In
Standard view, a user will have the option of configuring a SIP Config
tab, Features and Dial Plan settings. In Advanced view, the user is given
additional options under these tabs and the option of configuring Quality
of Service, Network Address Translation (NAT) and Voice Features.
Quality of
Service - Advanced View
Settings
under the Quality of Service tab are as follows:
Layer
2
Layer
3
The QoS
parameters may be switched between ToS and DiffServ by clicking the button
as shown:
Click
here
for more information on ToS and Diffserv conversions.
Layer
3 DiffServ
RTP Traffic, Call Control Priority
and Other Traffic levels may be set when Layer 3 Mode is set to DiffServ
(Differentiated Services).
Layer 3 ToS
Allows
turning on or off the service variables shown above, as well as level
of RTP, SIP and Other Precedence. Numerical priority is set on a range
of 0-7, 0 being lowest and 7 being highest. This determines the priority
of traffic for the respective type of service.
Type
of Service settings control the efficiency at which data packet traffic
is forwarded. Setting the associated switch to On/Off will determine traffic
settings of RTP, SIP or Other, respectively:
- Min Delay - data packets will
be forwarded with minimum delay.
- Max Reliability - data packets
will be forwarded with maximum reliability.
- Max Throughput - data packets
will be forwarded with maximum throughput.
- Min Cost - data packets will
be forwarded with minimum cost to network bandwidth.
